FAQ

A: There a lot of approaches to cleaning fuel injectors. Most are a combination of sprays, fluids, hoses and brackets that do not clean the injector properly. Also, many mechanics do not replace the filters. Ours is a professional-level, ultrasonic fuel injector cleaning machine, testing and reporting process for one low price per injector.
A: The cost to clean is currently $21.00 per top feed injector and $25.00 per side feed injector. This is a very competitive price for fuel injector cleaning plus we offer FREE standard return shipping(purchase must be over $80.00) in the continental United States with faster shipping options available. Most businesses have you pay for return shipping.
A: Dirty and clogged injectors can cause classic engine problems, lean misfire, rough idle, hesitation, loss of power, and higher emission levels of unburned fuel, engine failure and carbon monoxide.

It doesn’t take much of a restriction in an injector to lean out the air / fuel mixture. A 10% restriction in the fuel flow of a single fuel injector can be enough to cause a lean misfire. When this occurs, unused oxygen enters the exhaust and makes the O2 sensor read lean (too little gas, too much O2). If the O2 sensor reads lean, then the computer will compensate by increasing the on time of the next injector(s) to fire, resulting in a now overly rich fuel condition. Now dirty hydrocarbon emissions (due to unburned fuel) and carbon monoxide emissions will rise in the cylinders that are now getting too much fuel. This is one cause of carbon and debris deposits on the injectors and the valves.

The computer can only analyze the combined exhaust gases, and it averages out the air / fuel ratios. One or more clogged fuel injectors will cause some cylinders to run leaner, and the computer will then compensate and then cause other cylinders to run richer. This results in drivability and emissions issues.

Most customers experience a 10 to 15% improvement in gas mileage after getting their injectors cleaned and flow tested! Why pay for new fuel injectors when we can service them to “like new” for a fraction of the cost of new injectors?

Getting your injectors cleaned and flow tested saves you money and just makes good sense!

A Bottle of Fuel Injector Cleaner Poured into Your Gas Tank Will Not Fix the Problem!

Pouring a bottle of fuel injector cleaner into your gas tank is not effective at cleaning baked on carbon, gum, and varnish out of your fuel injectors. The bottled fuel injector cleaning agents are simply too diluted to be effective. Bottled cleaning solvents can be harmful to your fuel system components. They loosen deposits in the fuel system that then flow to the injectors and plug the small filter and injector. If the injector is severely clogged, then it will not even pass enough cleaning solvent through it to do any good anyway!

Our fuel injector cleaning service uses ultrasonic cleaning tanks that “blast” the deposits off of the fuel injectors using sonic pulses. Ultrasonic cleaning completely removes even the most stubborn baked on deposits off of the fuel injectors. Unlike bottled cleaning solvents, the cleaning solution used in our ultrasonic tanks is environmentally safe, biodegradable, and will not harm the fuel injector components. The computerized injector drive unit cycles the fuel injectors on and off while they are being ultrasonically cleaned, and this also breaks up and pushes dirt out of the injector.
A: We service most gasoline fuel injectors including all:
  • Top Feed
  • Side Feed: OPTI--MAX (GDI), along with the mating air injector, Nippon Denso, Ford Zeta/Siemens, Chrysler 3.5L, and similar Viper V- 10, GM TBI Maxi(throttle body injector)

  • For: Automotive, Truck, Marine, Outboard, Motorcycle, and ATV engines.
A: Our turn around time is usually 24 to 48 hours upon receiving the injectors. We can handle a large volume of injectors. If you need your injectors done ASAP, don’t worry, Give us a call and we can accommodate you.
A: The only reason to replace an injector is it has a bad coil and that is unlikely.
A: Absolutely not, we do not charge for non repairable injectors.
A: Yes we do. Our injector cleaning and flow testing service and parts orders include free shipping for US customers with orders of $80 or more, but is not included in international shipments. International shipping is available thru the United States Postal Service 6 to 10 day International Priority mail for $23.95. When checking out in our PayPal shopping cart, the international shipping option is offered at the end of the checkout process. This price applies to orders of up to 10 fuel injectors. (which can fit in the USPS small flat rate box ). For larger orders, higher rates may apply.